spocket place

Features of simulation of tracked vehicles, soil models

spocket place

Postby morad.shadfar » Mon Apr 14, 2014 5:33 am

I'm using UM 6.0 trial.

Is there any way to change sprocket place (front, rear) manually? it's always rear!
morad.shadfar
 
Posts: 1
Joined: Mon Apr 14, 2014 5:28 am

Re: spocket place

Postby Dmitry Pogorelov » Wed Apr 16, 2014 11:17 am

Yes. Simply set the correct value of the Xc parameter on the "Sprocket" tab of the track designer (Figure 55 in page 47 of the file 18_um_caterpillar.pdf). The parameter corresponds to the longitudinal position of the sprocket center.
Dmitry Pogorelov
UM Team
 
Posts: 3
Joined: Thu Jan 30, 2014 3:01 pm


Return to Simulation of tracked vehicle dynamics

Who is online

Users browsing this forum: No registered users and 1 guest

cron